Author Topic: Sticker Application  (Read 1489 times)

0 Members and 1 Guest are viewing this topic.

Offline Bertie

  • Founder Of AOC
  • Administrator
  • 695 Member
  • ******
  • Posts: 947
  • Thanks: 40
    • View Profile
    • Abarth Owners Club
  • Registration Number: F5 BSB
Sticker Application
« on: February 21, 2015, 01:58:44 PM »
Here are instructions for the application of your stickers;

Firstly, ensure the surface is clean, cool and dry. It should be free of any dirt or dust, as this will reduce their ability to adhere.

1. Slowly peel the top clear layer from the sticker. This should pull the individual characters with it. If not, lay the application layer back over the sticker, and rub over the lettering as you are slowly pulling. Sometimes, a very sharp fine knife is useful to help lift the sticker from its backing.

2.Once the sticker is free from the backing, and on the applicator tape, apply to your desired location. Lay it down from left to right, ensure no air is trapped.

3.Using something soft (microfiber towel works well) gently rub the sticker so it adheres to your chosen surface.

4. Leave it for a few minutes to adhere, then slowly pull away the applicator layer.

5. Run over the sticker with your finger to remove any air bubbles.

6. You should try to avoid getting it wet or washing it within the first 12 hours of application.



*Disclaimer* Abarth Owners Club are not responsible for the miss application of your stickers, and will not provide a second set if you make a mistake during application.
Abarth 124 Spider | San Marino Black | Visibility Pack | Bose Audio | Satnav | #280 of 2000